Library

Website providing a link for purchasing NFPA 914, Code for the Protection of Historic Structures.

Fact sheet describing what builders need to know about designing a structure for flood loads.

A website explaining the various shades of light, from warm to cool colors, with a visual diagram illustrating the various shades of light.

Fact sheet that details the steps needed to perform a combustion appliance safety inspection to determine if fossil fuel-fired appliances are operating safely under a depressurized condition.

List of commercial heat pump water heater systems that comply with NEEA's Advanced Water Heating Specification.

An article illustrating common errors found in fiber cement siding installations. Many of these errors and poor flashing examples apply to siding materials beyond fiber cement siding.

Manual assisting architects, engineers, owners and roofing contractors for designing, specifying and installing roof tiles in areas of snow and ice.

Installation manual describing proper installation practices, industry standards and the code requirements of roofing tiles.

Article about how mortar droppings during the installation of a brick veneer can clog the weep holes in the wall assembly causing moisture damage. The article also illustrates products that can be installed in the ventilated cavity to mitigate this problem.

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height. Walls with...

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel sheathing (WSP) as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 inches thick over the WSP, and a cladding system installed over the foam sheathing in low...

Website providing building science based guidance and training for residential construction.

The Consumer Product Safety Commission (CPSC) requirement for clothing storage units (CSUs) to be tested for stability, exceed minimum stability requirements, be marked and labeled with safety information, and bear a hang tag providing performance and technical data about the stability of the CSU.

Document presenting step-by-step process for installing rigid insulating sheathing over wood studs or house wrap.

Article describing research encouraging use of exterior insulation to warm interior sheathing surfaces in walls and roof assemblies to reduce the likelihood of condensation during cold weather

Standard covering requirements for the assembly, installation, maintenance, and operation of controls and safety devices on automatically operated boilers directly fired with gas, oil, gas-oil, or electricity, having fuel input ratings under 12,500,000 Btu/hr.

Report describing the analytical study of renewable energy retrofits to homes built before 1980 and whether it is cost efficient or not.

Technical bulletin addressing surfacing options in regards to composite wood panels and their emission barrier capabilities.

Information sheet about crawlspace insulation, including installation details.

Standard describing prediction, mitigation, and reduction of moisture damage to the building envelope, materials, components, systems, and furnishings, depending on climate, construction type, and HVAC system operation; the webstore allows preview or full purchase.

A presentation describing the details of the ENERGY STAR Multifamily New Construction program requirements.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Lessons Learned chapter focuses on successful deep energy retrofit projects throughout the U.S.

Report explaining the principles of seismic design to architects.

Report identifying codes and standards that embody the concepts of resiliency.

Website providing information on U.S. residential and commercial building codes including adoption status.

Website listing implementation timelines and links to various versions of the DOE Zero Energy Ready Home national program requirements.

Homepage for DOE's Zero Energy Ready Homes program.

Checklist for the DOE Zero Energy Ready Home National Program Requirements Mandatory Requirement 7 (Renewable Ready).

Fact sheet poster describing benefits and qualification of U.S. Department of Energy (DOE) certified Zero Energy Ready Homes and providing eight examples of certified homes.

Information about dense pack, cellulose insulation.

A quick guide from the California Division of the State Architect (DSA) explaining the three types of gas shutoff devices to stop the flow of natural gas into buildings in the event of an earthquake or rupture of the gas line.

Report identifying two barriers that limit the ability of builders to explore opportunities for higher levels of energy efficiency in housing: the use of duct system materials that inherently achieve airtightness and are right-sized for low-load houses, and, the ability to air seal fire separation...

FEMA guide containing recommendations on how to implement cost-effective measures that can help to reduce the potential hazards associated with earthquakes.

Standard providing minimum functionality requirements for earthquake-actuated automatic gas shutoff devices; applicable to systems carrying natural gas and propane, the devices are used in piping, equipment, and appliances typically found in structures of three stories or less.

Webpage providing information on using awnings to enhance outdoor living space.

Presentation describing the history of ECM motors, an overview of ECM motor technology, and a lesson on the installation of ECM motors.

Free online tool for sizing central heat pump water heater systems.

Website to support the state of Vermont transition to a more affordable and cleaner future by affiliate with partners throughout Vermont to save customers money, strengthen our state’s economy, and lower carbon emissions.

U.S. Code of Federal Regulations energy and water conservation standards for consumer products including home appliances and HVAC equipment.

Website describing analyses for products and standards affecting home heating, cooling, and appliances, in regards to technical, economical, and energy efficiency pathways.

Document providing descriptions of the many insulation options available to homeowners, along with guidance on where, when, and how to install insulation throughout your house.

A standard providing minimum energy efficiency requirements for buildings that are not low-rise residential buildings.

A standard providing minimum energy efficiency requirements for buildings that are not low-rise residential buildings.

A standard providing minimum energy efficiency requirements for buildings that are not low-rise residential buildings.

Website providing a listing of ENERGY STAR certified interior and exterior storm windows

ENERGY STAR factsheet describing the HVAC Quality Installation Program

ENERGY STAR website outlining the program requirements for NextGen, an EPA initiative aimed at advancing energy efficiency in residential construction.

Webpage for finding all the information you need to start shopping for ENERGY STAR certified products, including product details, rebates, and retailers near you.

Website showing compliance timelines for various versions of the ENERGY STAR Single-Family New Home program requirements with links to national program requirements documents and checklists.

Program criteria for residential exhaust fans used for ventilation.