Library

Report providing strategies to support occupant behavior changes for enhancing resilience, and to reduce a building's vulnerability to extreme weather, climate change, and loss of power.

A fact sheet providing tips on how to assemble a kit of food, water and other disaster supplies in the event of an emergency.

Report providing recommended designs and guidance for rebuilding homes destroyed by hurricanes in the Gulf Coast.

Report describing the REDi™ Rating System, which is a framework for implementing “resilience-based earthquake design,” a holistic “beyond-code” design, planning and assessment approach for achieving earthquake resilience.

An EPA guide describing the causes and impacts of summertime urban heat islands, promoting strategies for lowering temperatures in U.S. communities.

Article describing moisture and ice dam issues in attics and how to air seal the attic floor.

Guide providing information for professional builders and contractors rehabbing flooded single-family houses with emphasis on safe practices and the most important activities in the rehab process.

A user forum discussing ways to reinforce a gable overhand that was framed using the ladder method by Mike Mahan.

Table in the IRC describing bracing requirements for specified wind speeds and building story locations.

Research study identifying the best performing, most energy-efficient and cost- effective techniques to provide controlled mechanical ventilation and humidity control in hot- humid climates with thermally efficient building envelopes.

A fact sheet educating homeowners on the importance of residential safe rooms, including their cost and how to register a safe room with local officials.

Report describing the testing of various siding materials for their ability to resist bullets from small firearms.

Fact sheet describing how to install bracing to retrofit roof dormers for increased wind resistance.

A brochure educating homeowners on how to install self-locking devices on cabinets, drawers and doors, including child-proof latches and drawer locks.

Report on air-sealing programs for energy-efficiency retrofits.

Report describing extensive renovations to a historic home.

Fact sheet describing proper roof sheathing installation and illustrating fastening methods that will enhance the durability of a building in high-wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Q&A article discussing how to address moisture issues in an attic in a wet and humid coastal climate.

Factsheet from HUD describing how to properly rebuild following natural disasters in Puerto Rico.

Factsheet from HUD describing how homeowners can retrofit homes following natural disasters in the U.S. Virgin Islands.

Factsheet from HUD describing how to rebuild following natural disasters in Puerto Rico.

Factsheet for builders from HUD on how to rebuild homes following natural disasters in the U.S. Virgin Islands.

Report covering the planning, design, construction, and operation of residential and community safe rooms. Written for architects, engineers, building officials, local officials and emergency managers, and prospective safe room owners and operators.

Report on hybrid ventilation methods for insulated and sealed crawl spaces.

Report promoting public safety and welfare by reducing the risk of earthquake-induced damage to existing homes.

Report promoting public safety and welfare by reducing the risk of earthquake-induced damage to existing homes.

Technical report providing site selection guidance for installation of small wind turbines.

Webpage providing information about design snow loads and a free interactive ground snow load mapping tool for the contiguous United States, as well as snow load calculation methods.

Standard document establishing construction standards for one- and two-family dwellings constructed in high wind regions.

A website providing timely and accurate forecasts and watches for severe thunderstorms and tornadoes over the contiguous United States.

Report recommending strategies and approaches that the Federal government and other stakeholders may take to encourage and aid States and local communities in the adoption of the most current building codes.

Article describing three ways to strengthen the roof-to-wall connections in an existing home.

Article defining structural design loads and ways to calculate them, including dead loads, live loads, soil lateral loads, wind loads, snow loads, earthquake loads, and other loads.

Recovery advisory presenting key wind retrofit guidelines for buildings located in hurricane-prone regions. These retrofit guidelines are intended to help building owners and designers prevent or limit wind damage and water infiltration during high-wind events.

Article describing suggested food supplies, sanitation, safety, and cooking for during and after an emergency.

A research paper discussing the use of foundation heat exchangers for ground source heat pump systems in European climates.

This document covers a description of the need and applied solutions for supplemental dehumidification in warm-humid climates, especially for energy efficient homes where the sensible cooling load has been dramatically reduced.

Research study making several recommendations to whole-home program designers and implementers for improving the cost effectiveness and reach of whole-home programs.

Presentation by the Washington University in St. Louis Office of Sustainability on saving energy.

A guide for homeowners on determining the risks from tornadoes and hurricanes and selecting a safe room type and location, as well as providing detailed plans for safe room construction.

Report presenting safe room designs and showing the homeowner and builder/contractor or local design professional how to construct a safe room for a home or small business.

Fact sheet providing the wind resistant provisions of the 2015 International Residential Code.

Projectile missile testing of various wall panel configuration to understand how the different wall constructions would perform when struck with wind driven debris from a hurricane.

Report illustrating CAD drawings and modeling of bracing layouts for a gable roof truss.

Article from Green Building Advisor on the importance of window selection in hot climates, with an emphasis on window glazing.

Report descrbing an early study pointing to the significant improvement, >50%, of a hip roof in reducing peak wind-induced pressures.

Manuals describing design, materials, and installation techniques applicable to almost all types of roof systems; four-volume set includes Metal Panel and SPF Roof Systems, Membrane Roof Systems, Architectural Metal Flashing and Condensation and Air Leakage Control, and Steep-Slope Roof Systems.

A book describing seismic retrofits to help contractors and engineers understand how to properly retrofit a home in a cost-effective manner.

Guide describing details that serve as a visual reference for each of the line items in the Thermal Enclosure System Rater Checklist.

Standard 55 specifies conditions for acceptable thermal environments and is intended for use in design, operation, and commissioning of buildings and other occupied spaces; is the current version of the standard, which was published in the year 2021, and is available for preview and purchase at the...