Library

Article describing the difference between conditioned or unvented attics and unconditioned or vented attics.

Report on experiments comparing the cooling and heating seasonal and peak demand performance of different variable-capacity air conditioning and heat pump units.

Report describing costs associated with non-residential electric vehicle charging, including multifamily properties.

Fact sheet summarizing NFIP requirements, general guidelines, and recommendations concerning the construction and installation of decks, access stairs and elevators, swimming pools, and accessory buildings under or near coastal residential buildings; also published in FEMA P-499 “Home Builder’s...

Guidance document on deep energy retrofits.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Design and Construction Process chapter provides detailed guidance for each process phase: pre-planning, planning, construction, test-out and post-occupancy.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Lessons Learned chapter focuses on successful deep energy retrofit projects throughout the U.S.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Occupant Behavior chapter discusses how to assess homeowner behavior patterns and use these patterns to enhance overall energy savings.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Over Time, Phased Guidance chapter presents a phased approach to deep energy retrofits.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Reducing costs and Increasing Cost-Effectiveness chapter provides suggestions for controlling deep retrofit costs, including both 'do's' and 'don'ts'.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Source Energy and Carbon Decisions chapter helps users carefully assess the impacts of switching from gas to electricity for heating end-uses, using source energy and/or carbon emissions...

Fact sheet describing design and construction practices that reduce the likelihood of flood damage in the event that flood levels exceed the BFE, including illustrations of appropriate construction practices; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact...

Document providing design guidance and software tool information for forced-air HVAC systems.

Report providing information on ways to incentivize funding of hazard mitigation programs.

Information about dense pack, cellulose insulation.

Article describing the difference between swales and hugels (berms used to create soil from woody debris).

Information sheet with HVAC duct insulation, testing, maintenance and performance information.

Designer checklist covering hazards involving ground and surface water, rain and water vapor, HVAC and plumbing, sunlight, insects, decay, and natural hazards, and builder checklist covering all disaster resistance, sorted by building component.

Report on how airtighness changes as houses age.

Case study describing foundation wall moisture studies at a research facility in Minnesota run by Building America team NorthernSTAR.

Report providing an introduction to the NEHRP recommended seismic provisions for new buildings and other structures.

Presentation describing the history of ECM motors, an overview of ECM motor technology, and a lesson on the installation of ECM motors.

The objective of this research was to quantify the field performance of wood-frame walls clad with a variety of common claddings in a mixed-humid climate.

Article presenting a numerical study of wind pressure on the low-rise hip-roof building by varying the roof pitch using computational fluid dynamics computer modeling and wind tunnel testing of hip roofs with different roof pitches: 15°, 20°, 30° and 40°.

Fact sheet describing requirements and recommendations for enclosures and breakaway walls for their use below the BFE, including a diagram of a compliant wall system and examples of systems that have either resulted in increased damages or increased flood insurance premiums; also published in FEMA P...

Paper describing the effects of tree shade on residential electricity consumption and energy savings in summer and winter.

Technical report evaluating the energy savings potential of radiative cooling technologies, particularly photonic 'selective emittance' materials.

A standard providing minimum energy efficiency requirements for buildings that are not low-rise residential buildings.

Report describing the research gap in the connection between resilience and energy efficiency.

Report evaluating the accuracy of the regression technique used in 2006 by using the same least-squares regression analysis on data created from hourly energy simulation software.

Report describing the methods and results of a field evaluation of the energy performance of cellular shade window coverings.

Report describing a research study of the performance of interior low-E storm windows in two test houses at Pacific Northwest National Laboratory in Richland, WA.

Document providing an example procedure for establishing acceptance-range criteria to assess results from software undergoing BESTEST-EX.

Report on the performance of range hood exhaust fans.

Report presenting the process of a residential retrofit project for houses in the states of Florida and Alabama, including findings at the time of reporting and highlights of the first home to meet the target HERS Index of 70.

Report on high-R wall design called extended plate and beam that uses foam sheathing insulation with wall framing.

The New York State Energy Research and Development Authority (NYSERDA) is interested in finding cost-effective solutions for deep energy retrofits (DERs) related to exterior wall insulation in a cold climate, with targets of 50% peak load reduction and 50% space conditioning energy savings.

Article from Building Science Corporation on construction techniques for extreme heat conditions in Dubai and Las Vegas.

Information sheet about what length screws should be used, and how closely to space the screws when fastening furring strips to a foam-sheathed wall.

Newsletter reviewing federal disaster policy, the research basis for resilience, and three models of building resilient communities.

Guide discussing the siting of residential and community safe rooms at appropriate elevations and locations.

ICC 500 provides the minimum requirements to safeguard public health, safety, and general welfare relative to the design, construction, and installation of storm shelters constructed for protection from high winds associated with tornadoes and hurricanes.

Document describing ASCE 24-14 Flood Resistant Design and Construction changes and highlights, on topics including siting, materials, performance, and utilities.

Report of a field evaluation of four novel roof designs to see how each design would reduce space-conditioned energy use so that the knowledge gained could be applied to the design of new manufactured homes.

Report on field monitoring of inverter-driven ASHPs in cold-climate homes.

Report to understand the long-term moisture performance of unvented roof assemblies with fibrous insulation.

Report presenting the results from several demonstrations of a new method for sealing building envelop air leaks.

Map of the wind-borne debris region of Florida

Article describing five fundamental changes to building construction from the last 50 years and their modern construction consequences.

Standard providing a comprehensive approach to evaluating, selecting, specifying and installing flexible duct in HVAC systems.