Library

2009 edition of code for commercial buildings that brings together all structural, plumbing, mechanical, fuel gas, energy and electrical provisions for all buildings except detached one- and two-family residences and townhouses up to three stories.

2009 edition of code establishing a baseline for the design and installation of fuel gas systems and gas fired appliances through performance requirements.

2009 edition of code for residential buildings that creates minimum regulations for one- and two-family dwellings of three stories or less, bringing together all building, plumbing, mechanical, fuel gas, energy and electrical provisions for one- and two-family residences.

Florida building code including all the amendments and additions by Florida for the wind-borne debris regions and the high-velocity hurricane zone.

Document describing portions of the flood provisions from the 2018 editions of the IBC, IRC, IEBC, IMC, IPC, IFGC, IFC, ISPSC, IPSDC, and ICC Performance Code.

Article from the Sierra Club explaining 5 steps to take to ensure your home's resistance to wildfires, including site maintenance and roof construction guidelines.

Article describing seven reasons to mulch gardens.

Paper describing a proposed method for quantifying tree and vegetation evapotranspiration effects on city climate

Report describing an air distribution system composed of a series of uniformly-sized ducts that terminate in rooms throughout the home and return to a central manifold, similar in fashion to a “home-run” cross-linked polyethylene plumbing system.

Article describing methods for thermally isolating a garage in a Passive House-certified multifamily building.

Report describing approaches to using less wood in home building that minimize waste.

Fact sheet describing advanced wall framing.

Report describing the experience gained from AIA’s Disaster Assistance Program with first-hand accounts of disaster response and recovery, case studies and other best practices, including approaches to designing buildings to be more adaptable to uncertainty.

Article describing recessed lighting, which if installed incorrectly may contribute to air leakage and compromise building envelope efficiency.

Brochure describing the benefits of air-sealing for homeowners.

Webpage providing mapping tool for obtaining ground snow load, based on ASCE 7-10, for any location in the contiguous United States, with the exception of locations requiring a case study due to extreme local variations in ground snow loads. Fee required for some data.

Article by the Canadian Government on attic ventilation and considerations for moisture and ice dams.

Report describing approaches to insulating basements in homes built to meet Energy Star levels of performance of heat loss reduction.

Fact sheet describing basement insulation considerations.

Code establishing the rules of safety relating only to pressure integrity for the design, fabrication, and inspection of boilers and pressure vessels during construction which was published in the year 2017 and is available to order at the referenced link.

Webinar answering code-related questions on duct leakage tests, moisture levels in attics and crawlspaces, combustion equipment in conditioned attics, ventilation in multifamily buildings, and continuous insulation in residential construction.

Report providing water management details for roof assemblies.

Article published by American Society of Civil Engineers on different building types and their effectiveness resisting extreme heat from a building envelope perspective.

Information sheet containing images and descriptions of cantilevers.

Website providing weather data.

Report assessing the science of climate change with a focus on the U.S.

ENERGY STAR clothes dryer buying guidance for consumers.

Study investigating measured cooling energy performance in side-by-side identical homes with varying roof types, including cool roof technologies.

Attachment or installation of foundations, floors, roofs, insulation, utilities, and finishes to concrete masonry walls as well as on special tools and fasteners available for use with concrete masonry.

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height. Walls with...

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel sheathing (WSP) as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 inches thick over the WSP, and a cladding system installed over the foam sheathing in low...

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel (WSP) sheathing as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 in. thick over the WSP, and a cladding system installed over the foam sheathing in low...

Study reporting the results of comparative testing of the effect of finished and unfinished metal roofing systems on cooling energy performance in a test facility.

This study focuses on the design, construction, and performance of the interior chase approach as implemented by five different builders in Texas, North Carolina, and Florida.

Article from NAHB research center describing home building techniques for homes in hot climate zones.

DOE's consumer information about energy and laundry.

Handbook describing the permitting process regulating the transfer of stormwater from private property owners to the State of Florida Department of Transportation stormwater drainage systems.

Fact sheet describing how to prepare for hurricane season and mitigate damage from floods and high winds.

Fact sheet providing an overview of how to properly prepare for a winter storm and how to protect yourself before, during, and after one.

A guide for designers, architects, engineers, and fire experts on how to design rainscreen and ventilated cavities such that they don’t contribute to the spread of a fire.

Study reporting the results of comparative testing of the effect of various roof types on cooling energy performance in a test facility.

Checklist intending to clarify FORTIFIED Home™ eligibility requirements that relate to a home’s foundation.

Checklist providing prescriptive instructions on how to retrofit ladder framing on gable end overhangs to achieve a maximum depth of 18 in. from the face of the wall.

Fact sheet instructing installers about flashing installed on a FORTIFIED roof and points to roof covering manufacturers for flashing installation instructions.

Report covering the fire performance of combustible cladding over combustible insulation.

Report discussing the potential energy savings of new high-efficiency downlights, and the results of product testing to date.

Article describing how omission of two small but critical wall details, a kick-out flashing and a weep screed, lead to extensive water damage to a wall.

Fact Sheet describing the need for supplemental dehumidification, dehumidifier configuration options, and design considerations.

Article describing issues with condensation in unvented attics insulated with open-cell spray foam.