Library

2009 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

2012 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Code set from IAPMO explaining plumbing standards. 2018 publication.

Information sheet describing techniques for insulating basements.

Brochure providing information about flashing in all cimates.

Information sheet providing information about vapor management in building assemblies.

Brochure describing drainage planes, also referred to as water resistive barriers.

Handbook to help property owners understand the rules, procedures, standards, and criteria that apply to the environmental resource permit (ERP) program under Part IV of Chapter 373 of the Florida Statutes.

Document explores alternatives to riprap on banks and waterways to mitigate bankside erosion in the Pacific Northwest.

Web article discussing the primary approaches to waterproofing concrete foundations.

Information sheet about groundwater control.

Article discussing indoor water management.

Article describing a technique for installing a skylight and avoiding potential water leaks with the use of a peel-and-stick (or self-adhesive) membrane under the flashing.

A Recovery Advisory guide reccomending practices for designing and installing metal roof systems that will enhance wind resistance in high-wind regions (i.e., greater than 90-miles per hour [mph] gust design wind speed).

An NFPA standards document that provides minimum requirements for the design, construction, installation, and maintenance of tanks and accessory equipment that supply water for private fire protection.

Article describing how to properly manage condensing HVAC equipment.

Report addressing flood, wind and seismic hazards and recommends several multi-hazard resistant foundation designs of manufactured homes.

Report describing a comparison of hydrothermal performances of DryRightTM fiberglass batts and kraft-faced fiberglass batts in a south facing wall assembly with a moisture storage cladding material.

Document describing issues of wind pressure resistance in walls with exterior rigid foam sheathing installed directly over framing members.

Article describing a method for flashing roof vent boots, describing how to flash the pipe, how to flash over and under the pan, and finish by shaping the shingles, as well as addressing potential water leakage by adding an additional seal with EPDM flashing tape with a butyl adhesive backing to the...