Library

2018 edition of code for commercial buildings that brings together all structural, plumbing, mechanical, fuel gas, energy and electrical provisions for all buildings except detached one- and two-family residences and townhouses up to three stories.

Report providing builders in marine climates with guidance for building homes that have whole-house energy savings of 40% over the Building America benchmark with no added overall costs for consumers.

Document describing three methods for elevating a home out of the flood zone.

A publication highlighting recommendations that contribute to improved overall performance in the structural shell and focus on good connection details to tie together exterior walls, roofs and floors.

This Best Practices Manual is the product of Hammer & Hand’s ongoing work to document and internally codify our standard operating procedures for construction practice.

Document providing guidance to U.S. home builders who want to accept the challenge.

Guide describing measures that builders in the cold and very cold climates can take to build homes that have whole-house energy savings of 40% over the Building America benchmark with no added overall costs for consumers.

Guidance document providing BA research teams and partners with specific information and approaches to identifying and overcoming potential barriers to Building America (BA) innovations arising in and/or stemming from codes, standards, and rating methods.

Report summarizing research results for the 30% energy savings level and demonstrates that lead builders can successfully provide 30% homes in the Marine Climate Region on a cost-neutral basis.

Document detailing how to build radon-resistant homes.

Report describing a deep energy retrofit project for a two-family wood framed home located in Belmont, Massachusetts.

A list of EPA-certified wood-burning appliances for home heating for a range of budgets.

Report outlining the steps developers can take to create high-performance standards on a community-wide scale.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel (WSP) sheathing as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 in. thick over the WSP, and a cladding system installed over the foam sheathing in low...

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Design and Construction Process chapter provides detailed guidance for each process phase: pre-planning, planning, construction, test-out and post-occupancy.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Lessons Learned chapter focuses on successful deep energy retrofit projects throughout the U.S.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Occupant Behavior chapter discusses how to assess homeowner behavior patterns and use these patterns to enhance overall energy savings.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Reducing costs and Increasing Cost-Effectiveness chapter provides suggestions for controlling deep retrofit costs, including both 'do's' and 'don'ts'.

Wildfire construction guidelines from the Colorado State Forest Service focusing on site design and building materials to mitigate damage to homes in wildfire-prone areas.

IRC guide referencing wood truss bracing best practices and requirements.

Website blog with guidance about calculating heat-loss.

Article describing the flashing of roofs and what to look for, targeted at home inspectors.

Article describing mulching with lawn clippings.

Report discussing development of scopes of work and quality management for builders in mixed-humid climates.

Report investigating what motivates remodelers to become energy-focused and what technical knowledge that need to be energy-focused.

Report presenting ways public housing authorities (PHAs) can develop packages of energy efficiency retrofit measures the PHAs can cost-effectively implement with their own staff in the normal course of housing operations at the time when units are refurbished between occupancies.

Report designed to help a builder understand quality management and its role in transitioning from conventional to HPH building and remodeling.

Report informing building stakeholders about the risks a snow event poses to their buildings, preventative measures to take before the snow season, and actions that should be taken before, during, and after a snow event.

Manual describing the installation process for Craneboard insulated vinyl siding; while installation is similar across insulated vinyl siding products, see manufacturers for specific guidance.

Research study providing a comparison of selected retrofit activity typically done, versus that same retrofit activity approached from an integrated high performance remodeling and quality management perspective.

Report covering coating and back venting wood based claddings and trim.

Image depicting damage from termites in weatherboard cladding.

Article describing water leak detection and modes of testing (video camera inspection, hydrostatic pressure, electronic listening, isolation, and digital testing).

This text is one of series of supporting documents that provide guidance on implementing the World Health Organization (WHO) Guidelines for drinking-water quality; intended to support improvement of water safety within buildings.

Webpage describing how to flashing installation

Report providing design guidance for wood-framed residential construction in high wind areas where design wind velocity requirements do not exceed 140 miles per hour.