Library

Guide for homeowners describing how to find and seal basement and attic air leaks, determine if attic insulation is adequate, make improvements safely, and reduce energy bills.

Report on adding insulation to load-bearing mass masonry buildings.

A book about structurally insulated panels.

Document presenting some of the key technical properties of many of the most common building materials.

Article describing correct ways to attach rigid insulation to the exterior of commercial and residential buildings.

Report on heating and cooling air-distribution ducts that are insulated, installed close to the ceiling in a vented attic and covered with attic insulation to minimize energy loss.

Article describing the difference between conditioned or unvented attics and unconditioned or vented attics.

Case study describing foundation wall moisture studies at a research facility in Minnesota run by Building America team NorthernSTAR.

The New York State Energy Research and Development Authority (NYSERDA) is interested in finding cost-effective solutions for deep energy retrofits (DERs) related to exterior wall insulation in a cold climate, with targets of 50% peak load reduction and 50% space conditioning energy savings.

Report of a field evaluation of four novel roof designs to see how each design would reduce space-conditioned energy use so that the knowledge gained could be applied to the design of new manufactured homes.

Article discussing flow-through assemblies of walls.

Report assessing slab-on-grade foundation insulation energy savings.

Website providing builders with information about meeting RESNET Grade 1 criteria when installing insulation.

Information sheet providing links and resources for insulating basements in cold climates.

Siding installation guide for Ply Gem Siding Group products.

This Measure Guideline provides design and construction information for a deep energy enclosure retrofit solution of a flat roof assembly.

Report on two approaches to retrofitting existing double-stud walls.

Report describing a deep energy enclosure retrofit solution for insulating mass masonry buildings from the interior.

Report describing wall assemblies that use layers of rigid exterior insulation thicker than 1-½ inch and require a secondary cladding attachment location exterior to the insulation.

Report describing the use of mineral fiber insulating sheathing in a high performance enclosure retrofit package.

Guide providing information on controlling attic ductwork sweating.

Article outlining moisture accumulation in open cell spray polyurethane foam.

This page provides important information on how to protect yourself and your family if you suspect that you might have vermiculite insulation from Libby, Montana.

Fact sheet describing building envelope performance measures applicable to residential and small commercial construction.

Guide describing the installation of windows in walls that have foam plastic insulating; guide provides several methods for attaching, supporting, and flashing windows in walls with rigid foam sheathing. (Note: The link only goes to the table of contents for the guide, the full guide can be...

Article describing thermal bridging, construction practices that encourage thermal bridging, and solving thermal bridging through continuous exterior insulation.

Guide providing information on controlling attic ductwork sweating.