Library

Information sheet with information about insulating and ventilating attics.

Case study characterizing the framing factors for the exterior walls, ceilings, and floors of 180 wood-framed low-rise residential buildings across the United States.

Report identifying housing characteristics and energy use for fifteen single-family housing types and specifies measure packages that provide an optimum level of energy savings based on a BEopt analysis.

Report on the stability of furring strips as a means for cladding attachment over walls with thick exterior rigid insulation.

Article describing correct ways to attach rigid insulation to the exterior of commercial and residential buildings.

Installation manual for installing metal panel siding.

Research study describing an experimental and theoretical investigation of the energy and hygrothermal performance of retrofit foundation insulation systems in climate zones 6 and 7.

An article illustrating common errors found in fiber cement siding installations. Many of these errors and poor flashing examples apply to siding materials beyond fiber cement siding.

Report on heating and cooling air-distribution ducts that are insulated, installed close to the ceiling in a vented attic and covered with attic insulation to minimize energy loss.

Manual assisting architects, engineers, owners and roofing contractors for designing, specifying and installing roof tiles in areas of snow and ice.

Installation manual describing proper installation practices, industry standards and the code requirements of roofing tiles.

Information guide describing issues with concrete floors, in multiple climate zones.

Report covering insulating crawlspaces.

Article about how mortar droppings during the installation of a brick veneer can clog the weep holes in the wall assembly causing moisture damage. The article also illustrates products that can be installed in the ventilated cavity to mitigate this problem.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel sheathing (WSP) as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 inches thick over the WSP, and a cladding system installed over the foam sheathing in low...

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel (WSP) sheathing as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 in. thick over the WSP, and a cladding system installed over the foam sheathing in low...

Website providing building science based guidance and training for residential construction.

Document presenting step-by-step process for installing rigid insulating sheathing over wood studs or house wrap.

Article describing research encouraging use of exterior insulation to warm interior sheathing surfaces in walls and roof assemblies to reduce the likelihood of condensation during cold weather

Research report anayzing the results of a large retrofit project, turining an old school into near zero energy consumption apartments in Greenfield MA.

Article describing the difference between conditioned or unvented attics and unconditioned or vented attics.

Research study examining the opportunities for cost-effective energy efficiency and renewable energy retrofits in residential archetypes constructed before 1980 (Pre-Code) in 14 U.S. cities.

Information sheet about crawlspace insulation, including installation details.

Article discussing whether or not to seal and insulate crawlspaces.

Job Process sheet for the manufactured housing industry showing how to cut insulation batts to fit wall cavities in a factory production environment.

Article describing the importance of air sealing, insulation, and roof ventilation in reducing the likelihood of ice dam formation on roofs in cold snowy climates.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Lessons Learned chapter focuses on successful deep energy retrofit projects throughout the U.S.

Report covering exterior energy retrofits of masonry buildings.

Guide informing architects and engineers about designing buildings to be constructed with structural insulated panels.

Information about dense pack, cellulose insulation.

Information sheet with HVAC duct insulation, testing, maintenance and performance information.

Case study describing foundation wall moisture studies at a research facility in Minnesota run by Building America team NorthernSTAR.

Webpage from U.S. Department of Energy describing using Earth-Sheltered home building techniques in hot climate zones.

Report on problems and solutions with EIFS stucco wall cladding systems.

Report outlining the steps of translating a new home construction scope of work (SOW) to SOW for retrofit.

Website describing the U.S. Environmental Protection Agency's ENERGY STAR New Homes and Apartments program with links to builder and homeowner resources.

Document providing descriptions of the many insulation options available to homeowners, along with guidance on where, when, and how to install insulation throughout your house.

Research study examining efficiency retrofit opportunities, typical renovation practices, and pathways for achieving U.S. Department of Energy (DOE) goals for existing homes in Florida.

Report investigating performance and energy savings potential of heat pump water heaters.

Document presenting a simple starting point to determine the most cost-effective Energy Savings Measure Packages (ESMP) for existing homes to achieve 15% and 30% savings in 37 locations across the United States.

ENERGY STAR factsheet describing the HVAC Quality Installation Program

Section 608 establishes EPA’s National Recycling and Emission Reduction Program designed to reduce emissions related to maintaining, servicing, repairing, and disposing of air conditioning or refrigeration equipment.

Homebuilding’s simple payback estimator for an insulation upgrade – the type and amount of insulation, square footage of the area, recent utility bill, and a quote from insulation contractor.

Information sheet briefly summarizing double stud with spray foam wall construction including the advantages and disadvantages of this construction strategy.

Information sheet that summarizes Insulated Concrete Form (ICF) construction including advantages and disadvantages of this construction strategy.

Report exploring feasibility of designing prescriptive retrofit measure packages for typical Chicago region multifamily buildings in order to achieve 25% source energy savings.

Report analyzing results in crawlspace retrofits in multifamily buildings.

Report summarizing post-retrofit results for 13 existing homes in a deep energy retrofit pilot program.

Case study on exhaust ventilation and corresponding outdoor air intake strategies implemented in high-performance new-construction multifamily buildings.