Library

Standards book discussing the minimum standards of total system balance of HVAC systems.

Standard providing a universally accepted definition for quality installation for residential and commercial heating, ventilating, and air conditioning applications.

Document detailing the requirements, roles, and obligations for participants in an organized effort, ensuring that HVAC installations comply with the ANSI/ACCA 5 QI – 2010 (HVAC Quality Installation Specification) QI Standard.

Report describing two retrofit duct sealing techniques - manually-applied sealants and injecting a spray sealant, that were implemented in several low-rise multi-unit buildings in North Carolina.

Report describing a field investigation of failure rates of whole-house mechanical ventilation systems installed in Florida homes.

Web report explaining how correct filter sizing is an issue that applies to all new and existing homes that use ducted HVAC systems.

Report describing combined space- and water-heating (combi) systems using a high-efficiency direct-vent burner.

Report describing how space-conditioning systems are operating in the field and if these systems are meeting required standards.

Report outlining the issues with using existing ducts with a new low-load HVAC system, which reduces throw at supply registers causing decreased mixing of supply and room air, leading to potential thermal comfort complaints.

Report identifying two barriers that limit the ability of builders to explore opportunities for higher levels of energy efficiency in housing: the use of duct system materials that inherently achieve airtightness and are right-sized for low-load houses, and, the ability to air seal fire separation...

Bulletin describing the components of ECM motors and comparing their efficiency with PSC motors.

Research study describing experiments run in an unoccupied 1600 square foot house to evaluate the delivered performance as well as the relative performance of a SEER 21 variable capacity heat pump versus a SEER 13 heat pump.

Technical report presenting the results of an evaluation of homes using high-efficiency mini-split heat pumps to supplement the primary heating and cooling systems.

Report detailing the effects of replacing PSC motors with more efficient, variable-speed motors.

Technical report describing the evaluation of four different ventilation strategies for providing make-up air in high-performance, new construction multifamily buildings in the Northeast, emphasizing the challenges posed by increasing airtightness standards and the variability of system performance...

Report describing research that helps inform best practices for air-sealing multifamily buildings in the Northeast.

Article describing RESNET guidance on evaporative coolers.

Article describing benefits of ECM motors and how they can be installed as retrofit motors in HVAC equipment.

Standards criteria supporting ICC HVAC duct support standards.

Report summarizing the status of a central hydronic heating system project in multifamily housing at the conclusion of the 20112012 heating season.

The study described in this white paper is based on building energy modeling with an important focus on the indoor humidity impacts of ventilation.

Report describing as-found interior platform return plenums, the magnitude of their contribution to the total amount of duct leakage, and techniques and results of retrofits executed by the HVAC trade during equipment replacement.

Report providing step-by-step instructions for heating contractors and hydronic designers for selecting the proper control settings to maximize system performance and improve response time when using a thermostat setback.

Report describing the use of passive vents as a source of outdoor air in multifamily buildings.

This document addresses adding—or improving—mechanical ventilation systems to existing homes. The purpose of ventilation is to remove contaminants from homes either directly or by dilution. This report discusses where, when, and how much ventilation is appropriate in a home, including some...

Standard that prescribes a testing method to determine the efficiency of space heating and/or cooling thermal distribution systems under seasonal and design conditions. This version of the standard was published in the year 2014, and is available for preview and purchase at the reference link. The...

Information sheet providing guidance about the placement of ventilation approaches.

Research project aimed to verify whether homes in the New Jersey HPwES program achieved 30% source energy savings, and if so, what measures were implemented to achieve them.

Report evaluating mechanical AC precooling strategies in homes as a method for improving the load factor by shifting cooling operation from on-peak to off-peak hours.

Article describing how replacing permanent split capacitor (PSC) motors with electronically commutated motors (ECM) can boost bottom line for HVAC contractors as well as improve customer comfort and satisfaction.

Technical study exploring the impact of different installation faults on heat pump performance in a single-family house.

Study conducted to help determine cost-effective solutions for heating and cooling houses that are designed to be energy efficient.

Proposed HVAC filter labeling standard and underlying analysis by the California Energy Commission.

Standard that defines the roles of and minimum requirements for mechanical and natural ventilation systems and the building envelope intended to provide acceptable indoor air quality in low-rise residential buildings. This version of the standard was published in the year 2016, and is available for...

This Standard provides a consistent, uniform methodology for evaluating the airtightness of building envelopes and heating and cooling air ducts and the air flows of mechanical ventilation systems.