Log in or register to create Field Kits and Sales Worksheets. Why register?

Guides A-Z

Guide describing how to correctly air seal a wall with missing top plates or open wall cavities. 

Guide describing how to air seal attic access panels, doors, and stairs to provide a continuous air barrier at the ceiling.

Guide describing how to air seal bathroom and kitchen exhaust fans.

Guide describing how to air seal doors that are next to unconditioned spaces.

Guide describing ways to seal drywall to the top plate of an exterior wall to air seal the wall cavity.

Guide describing how to air seal duct and flue shafts. 

Guide describing how to air seal electrical wiring throughout a home.

Guide describing how to air seal around light tubes.

Guide describing how to air seal the gap between the drywall shaft wall (i.e., common wall) and the structural framing between units in multifamily housing.

Guide describing how to air seal around plumbing and other piping.

Guide describing how to air seal around recessed light fixtures. 

Guide describing how to air seal sill plates in new and existing homes.

Guide describing how to air seal a whole-house fan system.

Guide describing how to air seal the rough openings around doors and windows.

Guide describing blown insulation into exterior wall cavities of existing homes with minimal disruption to occupants.

Guide describing how to insulate a vented attic in an existing home using blown insulation added to the attic floor.

Guide describing how to insulate and air seal dropped ceilings and soffits to prevent air leakage.

Guide that illustrates how and when to encapsulate ductwork in unconditioned attics, increases the R-value of duct insulation, mitigating condensation issues and reducing air leakage.

Guide describing how to use a blower door test to determine building envelope air leakage.

Guide illustrating how to insulate a floor over unconditioned space with conditioned space above by adding insulation and air sealing.

Guide describing air sealing of non-ICAT recessed lights installed in accessible attics of existing homes.

Guide describing how to upgrade a wall with a floor overhang (or cantilever) on an existing home by adding rigid insulating sheating and or closed-cell spray foam insulation and air sealing.

Guide with information about how to upgrade a garage ceiling when a portion of the interior of the house is located directly above the attached garage by adding insulation and air sealing.

Guide describing how to apply an air control layer directly over existing wall sheathing, and cover by two layers of insulating sheathing held in place by vertical furring strips.

Guide describing how to upgrade walls that separate the garage from the house by providing a continuous air control layer on the garage side of the wall and adding rigid foam insulation.

Guide outlining how to retrofit an exterior wall and/or attic to provide continuous air sealing.

Guide describing how to air seal around duct shafts and flues installed through ceilings, walls and flooring in new and existing homes.

Guide describing insulation techniques for skylight shaft walls.

Guide describing how to apply spray foam insulation to ceilings in existing homes.

Guide describing how to install stucco over rigid foam insulaiton in new and existing homes.

Guide describing methods for insulating an unvented attic along the roof line.

Guide describing the design and installation considerations for recladding of above grade walls using insulated vinyl siding.

This guide describes how to install a rigid air barrier to separate the porch attic from the conditioned space. 

This guide describes how to install a rigid air barrier to walls behind fireplaces.

Guide describing wind washing and how to prevent it.