Guides A-Z

This guide describes IECC 2009 and 2012 and ENERGY STAR Certified Homes insulation requirements.

Guide describing application of a radiant barrier layer in the attic to block radiant heat transfer between hot surfaces and heat-absorbing surfaces.

Guide describing how to achieve RESNET Grade 1 installation standards, and meet/exceed code using batt insulation in existing walls.

Guide describing how to increase insulation in existing homes by installing batt insulation on the ceiling plane of a vented attic.

Guide describing how to add spray foam insulation to the underside of the existing roof deck as part of the conversion of a vented attic to an unvented, insulated attic.

Guide describing blown insulation into exterior wall cavities of existing homes with minimal disruption to occupants.

Guide describing how to insulate a vented attic in an existing home using blown insulation added to the attic floor.

Guide describing how to upgrade a wall with a floor overhang (or cantilever) on an existing home by adding rigid insulating sheating and or closed-cell spray foam insulation and air sealing.

Guide with information about how to upgrade a garage ceiling when a portion of the interior of the house is located directly above the attached garage by adding insulation and air sealing.

This guide describes RESNET Grade 1 level installation of insulation in walls, attics, and floors.

Guide describing how to apply an air control layer directly over existing wall sheathing and cover with two layers of insulating sheathing held in place by vertical furring strips.

Guide describing how to install spray foam on the exterior of the existing home after framing over the existing siding.

Guide describing how to apply spray foam insulation to ceilings in existing homes.

Guide describing how to insulate the walls of an existing home with spray foam insulation.