Guides A-Z

Guide describing how to frame and insulate corners to reduce the heat loss and gain though structural framing.

Guide describing how to insulate headers over doors and windows to reduce heat loss and heat gain through solid wood framing.

Guide describing how to frame and insulate exterior-to-interior wall intersections to reduce the heat loss and gain though structural framing.

Guide describing how to insulate a basement to improve the overall thermal performance of the building and provide more dry, usable conditioned space for home occupants and for HVAC equipment.

This guides describes how to insulate and air seal attic knee walls and floor joist cavities under knee walls.

Guide describing how to achieve RESNET Grade 1 installation standards, and meet/exceed code using batt insulation in existing walls.

Guide describing blown insulation into exterior wall cavities of existing homes with minimal disruption to occupants.

Guide describing how to create a capillary break at all crawlspace floors using polyethylene sheeting to manage moisture in crawlspaces.

Guide describing how to install a capillary break under a slab foundation using either polyethylene sheeting or rigid insulation installed over aggregate or over sand and geotextile matting.

This guide describes installation procedures for continuous rigid insulation to help provide thermal protection, reduce thermal bridging and provide a moisture barrier.

Guide describing construction and insulation techniques for double wall framing.

Guide describing installation of a fully sealed continuous weather resistant barrier to provide a drainage plane to keep rainwater out of above-grade walls.

Guide describing how to insulate a new foundation wall or an existing foundation wall by adding rigid insulation to the exterior side.

Guide describing how to install and properly integrate flashing at the intersection of the wall and roof on an existing home.

Guide describing how to upgrade a wall with a floor overhang (or cantilever) on an existing home by adding rigid insulating sheating and or closed-cell spray foam insulation and air sealing.

Guide describing how to insulate closed crawlspace walls and band joist areas with rigid foam board insulation.

Guide describing how to apply an air control layer directly over existing wall sheathing and cover with two layers of insulating sheathing held in place by vertical furring strips.

Guide describing how to upgrade walls that separate the garage from the house by providing a continuous air control layer on the garage side of the wall and adding rigid foam insulation.

Guide outlining how to retrofit an exterior wall and/or attic to provide continuous air sealing.

Guide describing insulation techniques for skylight shaft walls.

Guide describing how to install spray foam on the exterior of the existing home after framing over the existing siding.

Guide describing how to insulate the walls of an existing home with spray foam insulation.

Guide describing how to insulate an existing foundation wall by adding spray foam insulation to the interior side of the wall.

Guide describing how to install stucco over rigid foam insulaiton in new and existing homes.

Guide describing techniques for installing insulating sheathing as a continuous drainage plane on walls.

Guide describing the design and installation considerations for recladding of above grade walls using insulated vinyl siding.

This guide describes how to install a rigid air barrier to separate the porch attic from the conditioned space.

Guide describing how to insulate the sill beam or sill plate on the exterior side in a way that allows drying to the exterior, as part of an exterior wall upgrade.